Overhead Light Work
NCCamper > albums > Mods - Misc Interior
Album Info:
To install the light: 1-remove the center ceiling brace 2-pull back the road-side valence. 3-remove the road-side rear lifter arm cover (from inside the camper) 4-remove all screws and lower the road-side aluminum upper corner brace. 5-drill a 1" hole in the ceiling tile under where the middle of the ceiling brace was positioned. 6-drill a 1" hole in the ceiling tile 6" to the front of the other hole. This will position the light between the brace and door track. 7-force a THICK copper wire (or other device) through the styrofoam between the two holes to make a space for the wires. 8-fish a wire through the styrofoam and tap into the ceiling light feed running down the road-side top corner. 9-wire in the light and screw it to the ceiling with #8 x 1" metal screws. 10-remount the corner brace, being sure not to pinch the wire. Replace the lifter arm cover and center brace.
Sample Email
Below is what we'll send to your friends to invite them - edit or remove the optional note.
No comments so far...
To be able to leave a comment please Log in or Sign up.