• Close both ends of boxes to start.
  • Measure 6 inches up on side of box.
  • Draw a line across side of box where 6 inch marking is. Repeat this step on other side of box on
  • bring marking just a little over the edge of the side of the box on all four sides. Your marking
  • Connect the two marks using a ruler.
  • You will need to mark this on both sides.
  • Using X-acto or box knife and ruler to keep your lines straight, cut both larger sides first on
  • Then cut the smaller sides.
  • You will then have 2 boxes.
  • Measure contact paper large enough to cover both sides.
  • Don't be stingy with the contact paper, you will need lots.
  • Remove backing of contact paper and place box leaving a few inches on both sides of box and extr
  • Covering
  • Covering. Contact paper is very easily removed so I fold the corners over a little and tack them
  • Cut paper on the bottom going from center to bottom corner of box on both cornersmaking a triang
  • Fold Triangle piece up.
  • Fold edges of paper over side and bottom tab under.
  • Do this on both sides of box.
  • Cut paper down on top of box to the corner.
  • Trim excess leaving approx. 2-3 inches of paper.
  • Fold this over into the inside of box.
  • Trim excess of top pieces of paper leaving approx. 2 inches diagonally.
  • Trim corners diagonally.
  • Fold over inside of box.
1 2 next